Can anybody go measure the stock muffler dimensions, trying to fit the biggest can under my car. Much appreciated. I was thinking 8"...
Would you see any VE gain from a standard head to something that's fully built.
Too long?
Does anybody know if you can put a larger turbine onto the 2560 chra.?
If I have aftermarket castpr rods on the front of my car and swap stock back in will it change my toe allingment?
Having problems holding boost at high rpm. Its dropping from 18 down to 15. Its running a 3 port mac valve. With ams split dumps. I was...
Plese help, was thinking CZP, worried about customs. Any advice.
Why is my CZP one peice so DAMM noisy. It rattles and vibrates all over the place at low rpm. How do i fix it? It SOOOO BAD! Can i take the...
Ive lost a few bits for my 28r turbos. I have the CHARA but im missing the adaptor plate and big circlip that goes directly onto it. (this is...
Has anyone imported some turbos from spec z. Im thinking about doing so but im afraid of import tax and what not.
So i shipped my turbo center housing away to GCG Turbos. It had damage to the compressor wheel. I got a quote from them before i shipped it...
So i took my turbo off my head today, turns out it has eaten a bolt. And destroyed the fins. I was shocked but considering my luck, its to be...
Was thinking about running adjustable lower arms in my car. When you lower the car and the roll centre changes, how do you 'raise the roll...
So if i was running 1mm oversize pistions on a stock hear gasket with heads that have had 1mm taken off them what would it C/R be? Is it worth...
Debating bigger turbo/cams options. So the following may be for sale. 28r turbos $2000 ono. Stock refirb heads, but with 1mm taken off the...
Im taking the engine out to fix a boost leak at the turbo so nows the best time. Let me know what you think.
Can any body run out into their car and see where the acc feed comes from. Mine is modified. Its comming after the turbo. Is this correct?
Ever since new ive had this killer noise in my car. I think its from the driveshaft. I can move it foward and backwards a fair amount by hand....
Pulling guards is hard work, i must have had the car up and down 50 times. Spent the last few days doing this. Still got 3 to go. I set...
Well i was wondering where all my coolant was going. Turns out Ive done a headgasket. Typical bubbles in the coolant, and a very slight film of...
Separate names with a comma.