Thread dig. I've been given permission to buy a hoist and I'm chasing a 4 post as while I'm pretty sure my shed slab is deep enough, don't have a...
For some reason there are a few nice 2+0's on the market at the moment in SEQ, all at good prices. As someone who is now actively looking for a...
I thought that was more for rotors to keep carbon off the seals?
OK, I'll bite, what do you want for it? Were you still asking 14K or is it a more reasonable amount now? Someone just came around, looked at my...
Seriously, once bub is around 9 months old and you swing the baby seat around to forward facing, it'll fit in the back seat (depending on what...
From what I've read, the higher operating temps are used to reach emissions goals, not because it's best for the engine. Putting a lower temp...
As in cone nuts? Not sure about the copper coating though.
The old bearded guy from Chiptorque was on MCM for one of their projects. They flew him from the GC to sydney before haltech started sponsoring...
Drop the boost level to at low as what the controller will allow?
I'm assuming this is a street car, because once you hit the track, most warranties go out the window. There are plenty of brands out there, and...
Lol
It appears there are ways around that. 450ZX
After a very quick flick through their very amateurish looking website, all I'm getting is that it's some type of surface tension reducer that...
And the Accelerator pedal flat to the floor. Closed butterflies means you will have to crank longer to get a stablised figure.
Separate names with a comma.
