UAS Camber arms and tool question

Discussion in 'Technical' started by BoneZx, Dec 27, 2009.

  1. BoneZx

    BoneZx Active Member

    Messages:
    1,091
    Likes Received:
    4
    Trophy Points:
    38
    okay, i want to know if anyone has already installed the UAS front camber arms. and if you have and you post a pic up of it.

    and can anyone tell me where i can get the tool to remove the valves out of the heads.

    cheers bonezx
     
    BoneZx, Dec 27, 2009
    #1
  2. Chrispy

    Chrispy Pretentious Upstart

    Messages:
    12,888
    Likes Received:
    368
    Trophy Points:
    83
    Snap On make a tool to get the retainers off the valves. Not particularly expensive IIRC. Any reason, or just playing?
     
    Chrispy, Dec 27, 2009
    #2
  3. Hyper101

    Hyper101 Well-Known Member

    Messages:
    2,907
    Likes Received:
    29
    Trophy Points:
    48
    To get the retainers off ? I used a 6" long 1/2" extension put a small magnet in the female end pushed and down on the retainer. The magnet grabs the collets as they are relased , worked perfect and cost me Zero $.
     
    Last edited: Dec 27, 2009
    Hyper101, Dec 27, 2009
    #3
    Nigel300, heavytrevy and ZedEx like this.
  4. beaver

    beaver southern zeds

    Messages:
    5,816
    Likes Received:
    85
    Trophy Points:
    48
    Location:
    yarra valley
    Very

    clever move, :cool:
     
    beaver, Dec 27, 2009
    #4
  5. BoneZx

    BoneZx Active Member

    Messages:
    1,091
    Likes Received:
    4
    Trophy Points:
    38
    yeah

    just brought the snap on tool that eric has said to buy and yeah, i'm bored as shit. and i'm playing with the spare engine i got.
     
    BoneZx, Dec 27, 2009
    #5

Share This Page