OK , without all the "ohh its failside" and like remarks, what would you change to modify it to your likeing. Just looking for ideas , so keep it clean. Constructive coments please!!!! in pearl white (my car color) What i have to start with now Cheers Patrick
yes, I would run a saw flat on the fog lights and cut right through. caution, fiberglass particulates are cancerous.
What about making the middle flat across... Better for a fmic.... That way it still keeps your veilside theme going??
This idea has been done and was going to suggest the same thing. Not too hard to do and looks better too.
I believe it was jaybo who modified his c1 bar to be flat at the bottom. One of the things I'd change would be getting rid of the edge which runs horizontally above the main opening (between the two fog light holes). Flattening it would look better IMO!
I believe you might be right. That's going back a couple of years now. Might as well just buy a UAS/Greddy bar Cut the VS lower side sections (The sticky outtie bits from the wheel arch to the side duct) off and Fibreglass them to it.
Just remember its just an apron and you dont replace your rear bar:bash::bash::bash: :rofl::rofl::rofl:
jaybo did mod his. thing is, by the time you mod this enough to look good it will look like an imitation bomex or similar lol
