anyone around the blacktown area, SYDNEY want to help? PM me asap or just reply to this thread, i can't drive at night! im using the method where you ground the wire to the screw, but it didn't work and i don't want to waste $100 globes :angry::angry: please contact if you're able to help. followed the procedure but it doesn't work for some reason !
Help is at hand >> I gather that you have some H3 globes that have one wire tail each. Now, when you remove your present globe you will notice that in the rim of the headlight, near where the globe fits, there will be a Phillips Screw. Undo this very carefully as you don't want to remove it completely, just loosen it so that you can slip a wire or an open tongued spade connector under it. Now cut yourself a length of automotive electrical wire, about 100mm long. To this crimp/solder the open tongued spade. On the other end, crimp/solder a electrical spade that will connect into your wiring loom for the lights. Carefully place the open tongued spade under the Phillips Screw & tighten. Place your H3 globe into place & clip it in. You should now have two spaded wires protruding, place your light cap back onto the light after you have threaded the wires through. Place one spade into each section of the light loom that you would have disconnect when you first removed the loom & light boot. Job done, its that simple. Hope this helps you out. Cheers Kerry
