Holden V6 in to Z32 = FAIL!!!

Discussion in 'Non Technical' started by mungyz, Apr 8, 2013.

  1. mungyz

    mungyz Well-Known Member

    Messages:
    1,511
    Likes Received:
    37
    Trophy Points:
    48
    Someone brought this subject up here a little while ago

    NEK MINNIT:

    http://www.trademe.co.nz/motors/specialist-cars/competition-cars/auction-575699907.htm

    :rofl::rofl::rofl::rofl::rofl:

    Has been rocking around for a while but check out the AWESOME power output - even if that were measured on an Aussie dyno that's a weak effort :rofl::rofl:

    Pretty sure the general opinion of the forum was that is was a bad idea - well maybe here's some evidence of that.

    (I'm not stupid by the way and appreciate there must be more to it than what meets the eye as this SHOULD make a lot more power)
     
    Last edited by a moderator: Apr 8, 2013
  2. tassuperkart

    tassuperkart Its a lie I tell you!

    Messages:
    2,300
    Likes Received:
    26
    Trophy Points:
    48
    Hmmm... Ive heard all sorts of platitudes about these engines. Some rather recently.
    Blow-hard seems to fit.

    E
     
  3. Jamie

    Jamie Jamie The Hobbit

    Messages:
    2,251
    Likes Received:
    3
    Trophy Points:
    38
    Why?!?!?! A stock TT would beat that...

    Unless they thought they'd get some sort of amazing power and were horrified at the end result...
     
  4. tassuperkart

    tassuperkart Its a lie I tell you!

    Messages:
    2,300
    Likes Received:
    26
    Trophy Points:
    48
    Yup! That just about sums it all up!!!!! H5!!!

    E
     
  5. mungyz

    mungyz Well-Known Member

    Messages:
    1,511
    Likes Received:
    37
    Trophy Points:
    48
    Well it's not ficken blowing hard enough if it can only do 200Kws :rofl:

    I'm curious as to why it's quoted as 200kw @ 6PSI - can it not run more, did it have problems at more boost, was it set like that because the owner is chicken of more power?

    Standard internals might be the weak link so it has been set at 6PSI to save rods from exiting the block - but then why bother with all that drama fitting it for a pissy 200kws :rofl:
     
  6. mungyz

    mungyz Well-Known Member

    Messages:
    1,511
    Likes Received:
    37
    Trophy Points:
    48
    :rofl:

    "this car is going to be sick and make sooo much power!!!"

    Nek Minnit for sale on Trademe with less power than a relatively stock Z32 :rofl:
     
  7. tassuperkart

    tassuperkart Its a lie I tell you!

    Messages:
    2,300
    Likes Received:
    26
    Trophy Points:
    48
    Wel... I spose some goose would have to be the trailblazer and try it........ yer?
    E
     
  8. Jamie

    Jamie Jamie The Hobbit

    Messages:
    2,251
    Likes Received:
    3
    Trophy Points:
    38
    I could mod my NA to beat that turd :rofl:
     
  9. 8300zx9

    8300zx9 Active Member

    Messages:
    2,256
    Likes Received:
    1
    Trophy Points:
    38
    Hahaha I think the idea is that they want a simple red neck engine in there zed.... Found out it had no power....turbo'd it....still no power.... For sale

    :rofl:
     
  10. tassuperkart

    tassuperkart Its a lie I tell you!

    Messages:
    2,300
    Likes Received:
    26
    Trophy Points:
    48
    Baaaaahahahahahahahah!!!!!!!!!
     
  11. Evil Twin

    Evil Twin Time to 'Suit Up'!

    Messages:
    791
    Likes Received:
    2
    Trophy Points:
    18
    Hmmmm - I had some genius try and tell me the engine in my ZR6 Aurion was from a commodore just last week... North - South / East - West aside I know what I would rather put in the zed - if it come to that!
     
  12. stumagoo

    stumagoo Active Member

    Messages:
    1,216
    Likes Received:
    16
    Trophy Points:
    38
    I think that you may be right about stock internals idea, I wonder if the turbos being an afterthought because the NA install was to gutless is not too far from the truth as well.


    nice way to sum up the idea though.
     
  13. Romonski

    Romonski And Justice For All

    Messages:
    2,219
    Likes Received:
    9
    Trophy Points:
    38
    what an abortion. stupid bogans
     
  14. Big_al_TT92ZX

    Big_al_TT92ZX Tempted to own another Z

    Messages:
    69
    Likes Received:
    3
    Trophy Points:
    8
    Probably wouldn't handle more than 6lbs before bending a rod anyway.
     
  15. gmbrezzo

    gmbrezzo Moderator

    Messages:
    3,138
    Likes Received:
    8
    Trophy Points:
    38
    Gees mungyz, next you'll be telling us its got falcon seats :rofl:
     
  16. tassuperkart

    tassuperkart Its a lie I tell you!

    Messages:
    2,300
    Likes Received:
    26
    Trophy Points:
    48
    Above post moderated.... Cluttering thread......PMSL!

    E
     
  17. mungyz

    mungyz Well-Known Member

    Messages:
    1,511
    Likes Received:
    37
    Trophy Points:
    48
    Agreed how dare we let this jibber jabber fill such and informative & useful thread :rofl: :p
     
  18. mungyz

    mungyz Well-Known Member

    Messages:
    1,511
    Likes Received:
    37
    Trophy Points:
    48
  19. stumagoo

    stumagoo Active Member

    Messages:
    1,216
    Likes Received:
    16
    Trophy Points:
    38
    still probably faster than the holden powered one. :br:
     
  20. tassuperkart

    tassuperkart Its a lie I tell you!

    Messages:
    2,300
    Likes Received:
    26
    Trophy Points:
    48
    Ummmm.... yes.. well... errmmmmmm................ I spose it was someones vision.
    Howd they get it regoed with a carby???

    E
     

Share This Page