Exhaust Cam Gears

Discussion in 'Technical' started by syntax_X, Dec 15, 2013.

  1. syntax_X

    syntax_X Zed Head

    Messages:
    664
    Likes Received:
    0
    Trophy Points:
    16
    Just doing a bit of work on my engine and I noticed that when the bolts for the exhaust cam gears are finger tight theres a bit of play, more than a degree.

    Thoughts?
     
    syntax_X, Dec 15, 2013
    #1
  2. Chrispy

    Chrispy Pretentious Upstart

    Messages:
    12,888
    Likes Received:
    368
    Trophy Points:
    83
    Tighten them.
     
    Chrispy, Dec 15, 2013
    #2
  3. syntax_X

    syntax_X Zed Head

    Messages:
    664
    Likes Received:
    0
    Trophy Points:
    16
    Yeah i think you missed the point....

    Should i hold them toward or away from the intake gears when tightening, im sure it can make a difference...
     
    syntax_X, Dec 15, 2013
    #3
  4. Chrispy

    Chrispy Pretentious Upstart

    Messages:
    12,888
    Likes Received:
    368
    Trophy Points:
    83
    Approx in the middle will be fine.
     
    Chrispy, Dec 15, 2013
    #4
  5. SIM300

    SIM300 FAKE MODERAT0R

    Messages:
    5,058
    Likes Received:
    15
    Trophy Points:
    38
    Almost at 1,000 thanks, Chris :p
     
    SIM300, Dec 15, 2013
    #5
  6. tassuperkart

    tassuperkart Its a lie I tell you!

    Messages:
    2,300
    Likes Received:
    26
    Trophy Points:
    48
    Stuff it! Ill thank him anyway just to be the one thousandth thanker! Hah!

    E
     
    tassuperkart, Dec 15, 2013
    #6
  7. Chrispy

    Chrispy Pretentious Upstart

    Messages:
    12,888
    Likes Received:
    368
    Trophy Points:
    83
    Hooray!! Broke the ton :D
     
    Chrispy, Dec 15, 2013
    #7

Share This Page