dropped a new motor and loom into my zed, started up with the stock ecu so once i knew the motor started i connected my haltect to it, now the car wont start with either ecu. Ran a check on the stock ecu came up with fault code 13 (Engine temperature sensor circuit) anyone had this happen and if so whats the common issue if any and why it might not let me start my car? Cheers
code 13 brings with it retarded timing and increased fueling. Engine flooding during crank. Usually a dirty connector or faulty coolant temp sensor.
Thanks mate thats pretty helpful would explain a lot, know where i can get a new sensor or is it a nissan only thing?
