I've installed a 4.1:1 final drive gearing to the R230 (Leader gears). Speedo now reads approx 10% higher than actual speed (110km/h on speedo is...
It was drawn to my attention that I have not started a build thread. I've been visiting this place since 2006... my bad. For the whole 5 of you...
Good read. I daresay most of the vehicles around these parts haven't seen this kind of love. Even for an old hat like me there was a few...
http://i.imgur.com/1bqX8DR.jpg TL;DR [IMG] This was at the Pentagon.
Refresh my memory: I've locked out the hicas, and want to make it permanent with a na pump. I'm currently using a adapter to link the rear...
Cleaning out the shed, and have some parts for pickup only, by arrangement. Located teralba nsw (Lake macquarie)- 1h 15min up the m1 freeway from...
This is not a new issue, I just haven't got around to posting about it. After a dash removal for replacement of the RHD wiring loom to a LHD...
I would be lucky if I polished the Z once a year. Then again, I only drive the thing a handful of times a year also :p This is mainly due to...
Silicone Vs stainless / aluminium / rubber... what is the best material for minimizing heat soak into the intake system? I looked up some...
I've got the lockout bar installed, but want to get rid of the solenoid and all hoses. I've read the tt pump mod tech article, but it looks...
So my z was sitting broken for 8 months. Bad fuel, lost all is oil pressure, sitting in one place. I filled it up with fresh 98 ron, and...
I'm at the turn key stage of a full revamp of the ignition system. I'm getting code 55, but the motor won't crank. The noise I hear is similar...
I'm chasing a Heater core to replace my shot one while I have my dash out. I'm after the core and related taps and valves. I recall natrad can...
Shortly, I'll be fitting a replacement engine wiring harness, and looking for some tips and tricks for doing the job. Currently dash is out,...
I'm in the market for new coilpacks. I know some of the guys out there use split fire coil packs, and others have gone down different plans....
Specs as follows: Ball bearing core uas turbos, 12.5 psi on eboost2 Fmic, 2.5 exhaust. Street tyres, no traction. Rural airstrip, loose...
MY ECUtalk has thrown the following max Values in a drive yesterday: INJ: 99/99% TPS: 4.06V AFM: 5.115V Timing: 45° BTDC / -5° ATDC There...
Can anyone confirm the correct fuel hose for the under-bonnet fuel fittings? I've had no luck finding the right spec in the FSM- MA, EFEC or FE...
So I keep killing PTU's. On Tuesday I burned through my 3rd PTU in as many months (and probably under 300km). I've checked all my shitty wiring...
So I melted a PTU, and overfuelled a cat til it was glowing red. No big deal. Even after replacing the PTU, it's still a bit 'doughy' under load....
Separate names with a comma.