Oil Recommendation

Discussion in 'Non Technical' started by jamersss, Mar 7, 2013.

  1. zedman

    zedman Member

    Messages:
    260
    Likes Received:
    0
    Trophy Points:
    16
    Nulon 10w - 30w fast-flow for turbo engines
    used it for 9 years no problems engine runs quiet as a mouse
     
  2. Egg

    Egg ....

    Messages:
    1,429
    Likes Received:
    12
    Trophy Points:
    38
    I always believed...

    ...if the oil came out too clean it's not doing the job it should.

     
  3. Egg

    Egg ....

    Messages:
    1,429
    Likes Received:
    12
    Trophy Points:
    38
    I've ALWAYS had a slightly noisy...

    ...lifter or three.

    As long as I've had my Z I'd always have a slight tap at start-up that would disappear once operating temps were reached.

    I've just done an oil change with Mobil1 15w50 and for the first time in 13 years I get absolutely no lifter tick at start-up. I sometimes don't drive my Z for 2-3 weeks and it used to be especially bad if it was left more then a week... but now no noise whatsoever even after sitting for 3 weeks.

    Plenty of weights available in Mobil1 through GL Lubricants and I'm going to stick with Mobil1 from now on, and it's dirt cheap compared to buying locally.
    Stuff like the Mobil1 10W-30 EP(Extended Performance) might be the perfect choice. Not available in Australian market.
    http://www.gllubricants.com/index.php?p=1_3_Mobil-Pricelist
     
  4. Tektrader

    Tektrader Z32 Hoe, service me baby

    Messages:
    8,092
    Likes Received:
    122
    Trophy Points:
    63
    By clean, I mean its much much darker than normal, Obviously blackened, BUT when I put my fingers through it, Its almost translucent. Its obviously still capable of collecting much more in the way of contaminants before its actually DONE. Mind you the insides of my engines are VERY VERY clean.

    I am just changing it early............... @ 10,000 klms.
     
  5. yellow300zx

    yellow300zx Pimpin Ain't Easy

    Messages:
    266
    Likes Received:
    7
    Trophy Points:
    38
    My old commodore did the same thing, its the thicker oil I think you'll find not the brand that actually helped there in that case :p
     
  6. Egg

    Egg ....

    Messages:
    1,429
    Likes Received:
    12
    Trophy Points:
    38
    Well

    The last oil I used was Shell Helix Ultra 15w 50... had a 20 liter drum of this and I used this for a few years, before this I was using Redline 10w 40 and before this Valvoline.
    I think the Mobil1 is especially good as it does not drain out of the top of the engine as quickly as other full synthetics of a similar weight. :)
    I'm just stoked to have zero lifter tick @ start-up. :zlove:
     
  7. Egg

    Egg ....

    Messages:
    1,429
    Likes Received:
    12
    Trophy Points:
    38
    Another thing.

    One other thing, over the years I've perhaps seen ten in depth oil reviews with testing results... Redline, Amsoil, Royal Purple etc.
    I've NEVER see Mobil1 rated poorly in any of these tests, in the middle somewhere sure, or even leading the 'cheaper brands' but never the worst.
     
  8. jamersss

    jamersss Member

    Messages:
    801
    Likes Received:
    0
    Trophy Points:
    16
    OH, is that so?
    A lot of the yanks say good things about Mobil oil, maybe I should give it a try next oil change.

    I haven't gotten any lifter tick since I have been using Penrite 15W-40 though, but I am always on the market for trying new things!
     
  9. SuperZ

    SuperZ Resident Z lunatic

    Messages:
    1,477
    Likes Received:
    3
    Trophy Points:
    38
    Nothing wrong with Penrite


    Since you mention it -

    I use Penrite 15w-40 myself and haven't had any lifter tick since changing from Valvoline - so Penrite isn't that bad as some would suggest

    Mobil 1 is supposed to be one of the leading oils in knock/shear/bearing tests just behind amsoil, so it cant be too bad either


    :zlove:
     

Share This Page