Z32 Manual Engine loom into Auto

Discussion in 'Technical' started by tuff, Dec 13, 2019.

  1. tuff

    tuff Member

    Manual engine loom into auto car. Am I correct in my assumption (from looking at the main eccs wiring diagram) that it should be fine as long as we add in the 4 Auto wires to the ecu connector (pins 5, 14, 15 & 40) and then splice these straight into the AUTO Trans ECU basically same as would be happening in the engine bay connector on the (RHD) drivers fender

    http://www.ttxtz.com/images/ECCS_colored_m.gif
     

Share This Page