QLD 89 tt 2+0

Time has come to sell my car.

Mods can be found Here

Few little things that need to be fixed:
Needs new clutch, rear wheel bearings are starting to make noise, a few little interior fixes needed, front bar has a very small crack on the passenger side near where it connects to the quarter panel causing it to hang a tiny bit, front drivers quarter has had a jack placed in the wrong spot causing the skin to "bulge" slightly, there is a small dent in the left rear quarter right near the fuel cap where a wooden trolley rolled into it, all tires need to be replaced, windscreen has a scratch from the wipers right at the bottom of it.

Comes with two sets of wheels, 17x8 and 8.5 running 235 front and 245 rears, and a set of 18x9 and 9.5 running 245 front and 285 rears.

Also comes with an unused twinz rear bar with integrated diffuser, the moulding strips that go over the top of the car, and new windscreen cowels.

The Engine was built by Eric, formerly A2Zed, and puts out around 450hp to the wheels, this is running very conservative and could easily push over 500 with new wastegates and a better boost controller.

Car is unregistered and will not pass a safety cert without the tires and windscreen scratch fixed.

Am hoping to get around the $8000 mark, the engine alone has had over 30k put into it.

Will get some proper photos up as soon as i can, although she is definitely not about good looks:zlove:

 

Pictures

18x9 and 18x9.5 running 235 front and 285 rear


Front bar cracked and hanging


Windscreen scratch, enough to defect


Small dent from wooden trolley


Some numpty backed into me


Bulging front drivers quarter


17x8 and 17x8.5 running 235 front and 245 rear


Front and rear view, small hail damage on bonnet

 

Sold.