IMHO don't grind your crank. If you are spending $$$ you do not want to risk what several high power builds in the US have found after...
I am pretty sure it is BS, same as stock. see this thread:...
dude that is awesome Can you divulge some more details about who made it? :)
How did your current injectors ohm out? Unless they are bad you wouldn't want to replace them with POS Venoms though, they have a bad rep pretty...
good luck sir It makes me mad to hear your story :mad:
Why would it be beneficial? Just interested as to why you think this. I think the crossflow leads to an equilibrium condition if something is...
yes so it has been said That kind of relativism doesn't really address the issue if you don't give the differences between the products some sort...
yeah they flow better like 3% right? The issue for some people is that they are directly derived from MS manis. A claim that Vuk hasn't...
45 members in the VTD of Z1 ads Just sayin' because I highly doubt that they were a highly organized group of troublemakers. You pissed alot of...
Interesting I imagine if it was on the floor it would be difficult to get under it so that might be why you couldn't lift it, if you were to...
More like 200kgs 4 guys can lift it but be careful dude, if you can get under it it won't be a problem. It is about the same weight as a big arse...
True Perhaps the best path is to use a timing light to make sure the timing is spot on and then put an EGT gauge in as suggested by zx299 to see...
Yeah could be a problem if you are injecting alot You can get controllers that look at throttle position and rpm as well as manifold pressure....
In addition I was talking to a guy at work who used to be a drag racer today about your issue. He didn't think adding fuel would do a whole lot...
Not alot of info I can't tell you alot more about what it does sorry. NIStune doesn't seem to have fuel rate initial value adjustment at 0x79FF...
Accelleration increase fuel 0x7200? Hi Jedi, I am by no means an expert and so am just asking this out of interest, but have you tried...
SPL Parts in the US makes one too. They are about $500USD without the plumbing or $900USD with the plumbing. They have some race data showing the...
it's virtually free (apart from all the hours you spend) if you do the work yourself and rebuild the lifters. You might want to replace some other...
Wow that is damn cheap, I am tempted to buy them and ship them to the US! When you say "floor needs slight massaging to fit them so they sit up...
Experimental evidence that wider tires are better: In the dry only :D...
Separate names with a comma.
