Hello. Just need some advice regarding the tensioner piston. Currently doing a 100k timing service and I've got a issue with the tensioner piston...
No I never even heard of one. Any links to a pex like guide
Having some issues I can't seem to fix on the 300zx. Post plennum pull the car seems to be missing its power and under acceleration it's just...
Hey James I had mine leak before too. Turns out it pushed the whole pin out the back and left a open hole for oil to come out while engine ran....
Ams throttle cover Pm sent
most likely this group buy here saves on the shipping, those places will charge minimum $300-$400 in shipping and handling
That sounds like good idea to get nistune with a base tune to suit. What's something like that cost all up normally?
Car started first try haha can't believe it !!!!! Going to put the original injectors back in or try get a eprom chip made up to include the...
unbelievable i stopped driving the car months ago because of this and all because i didn't pay attention when i pulled the lines off, so i put...
wait which side is the return line need to run from? i hope i haven't done some stupid stuff and feed the wrong side. this is my setup. driver...
the most recent work is going back more than 6 months where i changed a leaking injector and after that she wouldn't start. so checking for fuel...
hey guys i may have a FPR/FPD problem and want to double check what your opinion is before i buy an aftermarket FPR. so car wont start. fuel is...
Got all the parts mainly from other members here, all is done except tailshaft and tune. Getting to a point where I'm about to garage it for...
yer nistune is on the order after my tailshaft, just need something to get the engines last 1000ks of run in done safely
hey guys i need a new eprom .bin for a new chip. ive just installed 600cc injectors (thnx attila.z) and need a new .bin so the car can at least...
i want s2 as i hate those s1 connectors and i already have a sub harness for my injectors so its simple plug out old s1 sub and plug in s2 sub. i...
so having lets say 600cc injectors and running 400hp would be fine? like no loss in power or fuel econ (i know fuel econ should be the last thing...
im leaning towards s2 pintless injectors, and if u can get 400+rwkw on stock rail then ill keep using them :)
ok guys its time for some new injectors that are bigger than 370cc. im unsure on what size cc to choose for my application. some of you may...
lets just say my driveway has a few puddles to clean up xD
Separate names with a comma.