Found the following left over - Z32 TT Auto ECU - $20 1x Half Moon Seal good condition - Free TT Fuel Injectors - $10 Timing Belt Tensioner - $5...
Sold - cluster and boost leak tester.
Timing Belt, Heater Hoses and Fuel Filter gone.
Last part of the Z I have left.. Tomei 320KM/H cluster which was given to me as a gift and never had a chance to fit....
Sold the Z a few months ago. Would rather this spare stuff go to someone else compared to the bin. TT Oil Filter Tree FREE...
Short lived. I ended up selling the Z over the weekend for a very reasonable price. New owner seems good, so I hope he takes good care of her....
It has been a little bit of time since I posted. Had the timing belt, water pump and lower plenum replaced by Westside Automotive. Was very...
Everything went to plan. Z now running like a dream, and fixed oil leak(s) by replacing all hoses at bottom of engine. Flushed the cooling...
Was the car originally an auto, or always been manual?
My old white Auspec NA peeked 390,000km, before I sold her.. was still going strong, with cyl 6 at a little less compression than the others. It...
SO I made some progress: Wiring specialities alternator loom in Plenum painted All fuel, vacuum lines under hood replaced Billet Alloy...
I bought a bottle of Penrite HPR 15-60 full synthetic as recommended by lube guide today. Usually go Motul 10-40, but wasn't available....
For some reason when I put the car into ignition, the KM/H bounces up to 60. Leads me to believe it is shorting somewhere.
Car is factory manual with auto loom.. is the ECU auto or manual? When you hit the throttle, do the revs dip for a second, them come back up?...
So had a busy week. Got moving on the Z though - Wiring specialties alternator to transmission harness installed - New silicone Z1 oil cooler,...
Coated in melted plastic. Basically ran cheap and nasty wiring to the reverse sensor on the gearbox, over time the cable tie snapped loose the...
Lost my pair of vice grips. Found these bad boys at Bunnings. Absolute amazing. [img] Compare the pair. Old on left. [img] New...
Correct, one's that looked easiest were absolute hell. My method to keep the washers on while bolting up the banjos was by using a dab of gasket...
Had a fun night last night. Got two of the new turbo water lines in. Absolute PITA lining up the banjo and washers. [img] Decided to bend...
Fuel FILLER. Yes, the neck that is notorious for leaking where the insert goes in place. That isn't a GReddy exhaust, need a bit more light...
Separate names with a comma.