I'm tempted as I haven't really done much with the z club in the past and the only event I've been to was at black baz's house about 3 years ago,...
[IMG] Hopefully that works and is at a readable size. If it's not big enough let me know and I can upload a bigger version.
I'm almost tempted to go to this but then there is a Dyno day up here on the sunny coast on the 3rd of May too.
Think I have the machining part and labor part covered as uncle is a motor engineer but just putting out these questions for myself so im aware of...
Hi there guys so I just as of last night instead of being lazy like I have been for the last 2 years with my old motor, started to pull it down,...
Hey I live out in beerwah and need some lil small parts would it be alright to come around later today or some point this long weekend and see...
I'll take one set of the A pillars pending you being able to end to qld at my expense?
fixed and went for a drive, now for the other issue if anyone is able to help, last weekend I replaced half my air hoses connected them to where...
Can Can only give it a go, will let you know the out come.
yea front mount, the closer stock hoses i mounted to the top section on the cooler and the lower rear stock hoses connected to the bottom half of...
Hi there all so today I took off my front bar took off the cooler, everything went nicely, put it back together and now the z runs smoothe on idle...
I'll take the LED dash kit, contemplating the front strut brace also.
Hi there I'm curious as to what the power increase would be on a stock motor if I put 2 td04 turbos onto it, how much it may cost from anyone that...
Hi all just a general question, I wanted to add a little bit more sound into the cars exhaust system and went and saw an exhaust specialist today....
Thanks everyone for all the replies will take all factors into consideration and may get all things replaced even if not all are the issue, car...
Hey all I get my engine reaplced in my car just around christmas and ever since it has at times a knocking sound when under load (2000rpm) taking...
What condition is the brake master cylinder in? My ones currently leaking <_<
Well at its current state they have oil and fuel pressure and they also said the injectors have power aswell. As for the vacuum leak it could...
So just to get right to the point the local mechanics in town are putting a second hand motor into my zed, they say it will run but takes a fair...
Ok so Compression test was done today and the news ain't good. Cylinder 1: 0 PSI Cylinder 2: 140 PSI Cylinder 3:145 PSI Cylinder 4: 140 PSI...
Separate names with a comma.
