z1 radiator na to tt bar

Discussion in 'Technical' started by Stef, Jul 13, 2015.

  1. Stef

    Stef Active Member

    Messages:
    2,437
    Likes Received:
    15
    Trophy Points:
    38
    Z1 have a conversion bar to fit a tt radiator in the na bottom supports. They say it does not fit the oem tt radiator but a number of aftermarket ones like koyo , m mishimoto ams and howes.

    Anybody know how it does not fit the oem one and if any of the eBay ones will fit ?
     
    Stef, Jul 13, 2015
    #1
  2. Anti

    Anti 14.7 x 14.7 = 44.1

    Messages:
    7,850
    Likes Received:
    6
    Trophy Points:
    38
    Worth noting that the NA radiator is far wider than the TT, so should only be considered in an NA if you're doing a TT swap..
     
    Anti, Jul 13, 2015
    #2
  3. Stef

    Stef Active Member

    Messages:
    2,437
    Likes Received:
    15
    Trophy Points:
    38
    Swap well under way. Was going to move the na supports but then found the z1 kit which seems like a much simpler solution
     
    Stef, Jul 13, 2015
    #3
  4. Anti

    Anti 14.7 x 14.7 = 44.1

    Messages:
    7,850
    Likes Received:
    6
    Trophy Points:
    38
    Oh, cool! Moving the supports would be a bit of a pain but doable.
     
    Anti, Jul 13, 2015
    #4
  5. bRACKET

    bRACKET Do Right Dean

    Messages:
    3,037
    Likes Received:
    0
    Trophy Points:
    36
    Have a TT PWR Twin Pass and works perfectly with the conversion bracket.
     
    bRACKET, Jul 14, 2015
    #5
  6. ryzan

    ryzan Moderator Staff Member

    Messages:
    2,898
    Likes Received:
    151
    Trophy Points:
    63
    Bracket is pretty average, doesn't fit my koyo rad. Just move the mounting points and be done with it. Radiator will sit a little bit higher at the top with the z1 bracket as well.
     
    ryzan, Jul 14, 2015
    #6

Share This Page