Rear glow panel high pitched buzzing with lights on...fix?

Discussion in 'Technical' started by Ztealth, Jan 30, 2008.

  1. SpaceFrog

    SpaceFrog Member

    Messages:
    364
    Likes Received:
    0
    Trophy Points:
    16
    Man I had no idea that these were available as genuine accessories. I thought they were all aftermarket, and DIY mods.

    I have the same bloody noise. I had no idea what it could've been. I've mentioned it a few times, but haven't gotten any answers.

    I don't have the OEM green panel. And since owning the car for 2 years have not seen it lit up. I've looked around in the boot area and have seen some spliced wiring, but had no idea what it was for. I'll carefully follow them and see If I can identify the inverter.

    Would I have to open up the center panel to disconnect the inverter?
     
  2. henpecked

    henpecked very small member

    Messages:
    791
    Likes Received:
    5
    Trophy Points:
    18
    99.999 probability of the inverter being OUTSIDE the panel.:biggrin:
     
  3. Mrmagoo

    Mrmagoo Member

    Messages:
    254
    Likes Received:
    0
    Trophy Points:
    16
    So thats the story about my rear panel

    Thanks Col

    Now I know where my rear came from
     
  4. BigCol

    BigCol That's what she said...

    Messages:
    2,034
    Likes Received:
    28
    Trophy Points:
    48
    You're welcome!
     
  5. ryanlok15

    ryanlok15 red zedder

    Messages:
    618
    Likes Received:
    1
    Trophy Points:
    18
    i love the door sills....the looks sooo good...i have never seen any aftermarket ones before...or any pictures of them actually...has anyone?
     
  6. Chrispy

    Chrispy Pretentious Upstart

    Messages:
    12,888
    Likes Received:
    368
    Trophy Points:
    83
    There was a GB or two ages ago.
     
  7. BigCol

    BigCol That's what she said...

    Messages:
    2,034
    Likes Received:
    28
    Trophy Points:
    48
  8. ryanlok15

    ryanlok15 red zedder

    Messages:
    618
    Likes Received:
    1
    Trophy Points:
    18
    ohhh man i wish there was another GB on these for the newer members...they look sooo cool...sooo many people got them...i wonder how hard it was to install?
     
  9. BigCol

    BigCol That's what she said...

    Messages:
    2,034
    Likes Received:
    28
    Trophy Points:
    48
    I had a stack of help from Jedi when putting my originals in. The originals are installed the same as the aftermarket ones - they are hooked into interior light relay located behind the passenger seat.

    According to her website, the aftermarket 'SMITHY' ones can be purchased through Caz...click me
     
    Last edited: Feb 16, 2008
  10. ryanlok15

    ryanlok15 red zedder

    Messages:
    618
    Likes Received:
    1
    Trophy Points:
    18
    i wonder if anyone else would be interested in a GB...they look sooo good though:D...i love em seriously:D:D:D
     
  11. SpaceFrog

    SpaceFrog Member

    Messages:
    364
    Likes Received:
    0
    Trophy Points:
    16
    I love the door sils. I remember reading about the group buy b4 i got my car. I would've bought 'em back then but wasn't 100% sure I'd be getting a Zed at the time.
     
  12. petes21st

    petes21st New Member

    Messages:
    2
    Likes Received:
    0
    Trophy Points:
    0
    Sorry to revamp an old post, where can i get an inverter replacement? and what type of inverter is it? i believe its a 12v Dc to 110V Ac, is this correct?
     
  13. BigCol

    BigCol That's what she said...

    Messages:
    2,034
    Likes Received:
    28
    Trophy Points:
    48
    Thats an excellent question - if anyone knows post up! My sills inverter has died and am looking for a replacement...
     
  14. petes21st

    petes21st New Member

    Messages:
    2
    Likes Received:
    0
    Trophy Points:
    0
    ok, i fitted a new one today so the panel is up and running, i bought one from a uk supplier www.rswww.com item no. 267-8863 , what you are looking for is this 'EL sheet inverter,12V 120mA rms 400Hz'.

    It was expensive but it works now.
    Also worth noting these replacements are slightly smaller than the nissan variant.

    There is also a member on the uk z club www.300zx.co.uk called 'Zed-Sean' who states that he sells them at a fraction of the cost so he might be worth a try.
     
  15. BigCol

    BigCol That's what she said...

    Messages:
    2,034
    Likes Received:
    28
    Trophy Points:
    48
    Thanks for the heads up!
     
  16. ryzan

    ryzan Moderator Staff Member

    Messages:
    2,897
    Likes Received:
    150
    Trophy Points:
    63
    Thread dig I know, but just wondering if you still had these pictures? I'm interested in adding a rear glowing panel and door sills. Was just wondering exactly what the rear quarter window sills are as I have never seen them before?

    Also, where would it be possible to get any of these parts from? I saw the gb thread on door sills which look absolutely awesome but its from 2005, and the sills arent listed on smithys place on caz any more :(
     
  17. BigCol

    BigCol That's what she said...

    Messages:
    2,034
    Likes Received:
    28
    Trophy Points:
    48
    300zx Altia Indiglo FAQ

    Here's a bit of a FAQ about the Altia Indiglo parts available for the 300zx!

    The Indiglo parts on the 300zx were made by a Nissan sub-division company called Altia. In the late 1990's Altia separated from Nissan.

    The 3 indiglo parts made for the 300zx are:
    1/ Rear Centre Panel
    2/ Door Sills (otherwise known as Kick Panels)
    3/ Rear Quarter Window Sill

    1/ Rear centre panel:
    Here is a normal rear centre panel:
    [​IMG]

    Here is an indiglo rear centre panel:
    [​IMG]

    You can tell a panel is an indiglo one by:
    a) the indiglo rear centre panel is maroon on the inside of the 300zx logo (see above)

    b) the indiglo panel only came in green (this is not to say that all green panels are genuine Altia / Nissan panels)

    c) The whole of the 300zx logo illuminates. This is a genuine panel:
    [​IMG]

    This is not (because it is red, and because only the outline is illuminated):
    [​IMG]

    d) The genuine panels came with a wiring loom that connect in to the black box that controls the rear lights (located inside the right rear quarter panel boot trim):
    [​IMG]

    Just as a FYI, here is a picture of the inside of a genuine panel:
    [​IMG]

    Genuine illuminated rear centre panels are the least rare of the illuminated products, but are still rare. As of early 2008 they are listed at AUD$1300, but cannot be purchased new any more.

    The standard rear centre panel can be converted to illuminate. There are tech articles in the tech section on how to do this. It is a messy fiddly job, but the end result can definately be worth it.


    2/ Door Sills

    Genuine illuminated door sills are less common than the rear centre panels. The standard sills are plastic, while the indiglo ones are aluminium, but retain a very similar shape:

    [​IMG]

    [​IMG]

    [​IMG]

    [​IMG]

    There are now some good aftermarket sills available. These can differentiated by their use of steel rather than aluminium.


    3/ Rear Quarter Window Sill

    The rarest of all the Altia indiglo parts is the rear quarter window sill:

    [​IMG]

    [​IMG]

    [​IMG]

    [​IMG]

    [​IMG]


    Thanks for reading!
     
  18. BigCol

    BigCol That's what she said...

    Messages:
    2,034
    Likes Received:
    28
    Trophy Points:
    48
    300zx Altia Indiglo FAQ

    300zx Altia Indiglo FAQ

    --------------------------------------------------------------------------------

    Here's a bit of a FAQ about the Altia Indiglo parts available for the 300zx!

    The Indiglo parts on the 300zx were made by a Nissan sub-division company called Altia. In the late 1990's Altia separated from Nissan.

    The 3 indiglo parts made for the 300zx are:
    1/ Rear Centre Panel
    2/ Door Sills (otherwise known as Kick Panels)
    3/ Rear Quarter Window Sill

    1/ Rear centre panel:
    Here is a normal rear centre panel:
    [​IMG]

    Here is an indiglo rear centre panel:
    [​IMG]

    You can tell a panel is an indiglo one by:
    a) the indiglo rear centre panel is maroon on the inside of the 300zx logo (see above)

    b) the indiglo panel only came in green (this is not to say that all green panels are genuine Altia / Nissan panels)

    c) The whole of the 300zx logo illuminates. This is a genuine panel:
    [​IMG]

    This is not (because it is red, and because only the outline is illuminated):
    [​IMG]

    d) The genuine panels came with a wiring loom that connect in to the black box that controls the rear lights (located inside the right rear quarter panel boot trim):
    [​IMG]

    Just as a FYI, here is a picture of the inside of a genuine panel:
    [​IMG]

    Genuine illuminated rear centre panels are the least rare of the illuminated products, but are still rare. As of early 2008 they are listed at AUD$1300, but cannot be purchased new any more.

    The standard rear centre panel can be converted to illuminate. There are tech articles in the tech section on how to do this. It is a messy fiddly job, but the end result can definately be worth it.


    2/ Door Sills

    Genuine illuminated door sills are less common than the rear centre panels. The standard sills are plastic, while the indiglo ones are aluminium, but retain a very similar shape:

    [​IMG]

    [​IMG]

    [​IMG]

    [​IMG]

    There are now some good aftermarket sills available. These can differentiated by their use of steel rather than aluminium.


    3/ Rear Quarter Window Sill

    The rarest of all the Altia indiglo parts is the rear quarter window sill:

    [​IMG]

    [​IMG]

    [​IMG]

    [​IMG]

    [​IMG]


    Thanks for reading!
     
  19. Sanouske

    Sanouske Retired Moderator

    Messages:
    2,543
    Likes Received:
    41
    Trophy Points:
    48
    Now that is some seriously cool lighting. I have never seen those window sills before. Its a shame that most of the forum stickers are in place of it now haha. I would attempt making up something similar.

    Can you tell me, is the illuminated lettering is stuck on the inside or outside of the glass itself. I couldnt imagine it being moulded into the glass, so in or out. lol.

    Oh and i wish i bought that indiglo rear panel from the Z wreckers down here. Was $50...long gone now, so its the company.

    Cheers.
     
  20. aazn

    aazn New Member

    Messages:
    1,981
    Likes Received:
    6
    Trophy Points:
    0
    i remember forum member badxtc has all 3 of them...
     

Share This Page