View Full Version : Z Related - Technical
- Cheap Cats
- Issue found... Front end vibration! (pics)
- D.I.Y head gasket replacement...possible or suicide?
- AIV Exhaust Plugs Z32 (for AIV removal)
- Wheel Balance and alignment
- Installing hatch rubber
- Window rubbers
- Cigarette Lighter removal.
- people with aftermarket radiators....
- Radiator and Oil cooler in one
- Thing u should do while engine is out??
- minimum rotor thickness/size?
- Wiring up power mirrors
- installing oxygen sensors
- Antenna/Aerial Problem
- Stillen 300ZX Engine Damper Brace
- DIAGNOSTIC read outs from your climate control
- Hatch Rubbers
- SPUN BIG_END BEARING, WHY ????
- turbo 2+2 auto and Na 2+2 auto tail shafts
- R33 brembo callipers
- Vac Line Question
- I just bought massive Porsche Brakes - will they fit?
- Pics of your zed with Tanabe or Eibach springs.
- Mandrel vs Press Bends
- Help N/A power loss
- turbo pipe
- Car shudder
- Will 2 seater seats bolt into 4 seater!
- Bloody Clutch!
- Leader Gears
- my first plenum pull
- Big End Bearings
- stock temp gauge
- Dump pipes
- Smoke faced temp gauge install question.
- Injectors
- Car feels like poo between 2.5K and 3K rpm
- Crack the diff what 2 replace
- EFI Harness LHD Differences
- Koyo 53mm Radiator Installation completed
- Jspec spark plug
- MicroTech ECU Diagnostic software.
- Problem with Koyo 53mm Radiator
- Braking Problem
- 02 sensor stuck
- Anybody fit James007 smic's ?
- Heater core Removal
- Engine Builders
- Auto Gurus help Needed, Recommend specialist shop in vic(long)
- HELP. Motor cutting out
- Help with car alarm...anyone ever had this problem?
- Strange (scary) TPS problem...
- Oil pressure guage not working.
- Drain holes...
- air con
- ZED in world of hurt.
- Zorst removal?
- Here is one of those "i have a problem but dont know what it is" threads.
- Another Plenum Pull Thread.
- Black on rear bar
- Hesitation problem
- targa tops
- URGENT!!!
- Under plenum by pass
- replaced or not?
- Balancing Question
- engine replace now the reading in odometer screwed??
- removing front bar
- Zed wont start!
- what does it cost
- fuel system Q
- missile switch EBC
- new here
- Spare TPS... keep it or sell?
- I have been searching but cant find IC spray kit
- Cruise Control
- boost gauge
- Need good mechanic in melb!
- ASI Performance
- NEED HELP!
- HID High Beams
- HKS ALC Automatic Line Controller Wiring Diagram
- Quick advice..
- How do you take the air con compressor out ??
- Power Steering Leak
- GTR R33 Brembo Brakes
- Wheel Studs
- A/C compressor question...
- Dumbo Question. Gasket sets
- FInished plenum pull!! BUT!!! Help Please??
- Slight rattle in alternator question - I think.
- Flex plate removal and replacement
- Running in safety boost
- rear spoiler...
- TAKING OFF the stock turbo dumps
- Lightened Flywheel
- Removing an oil pressure guage?
- 1st to 2nd Auto gear change
- need help on stalling
- 60mm intercooler piping?
- New Z, just few small problems.
- Fiberglass (gonzo) if you are out there lol
- How do i reset ECU?
- Warning possible bodge question :P
- plumb back bov
- Leaking Clutch Fluid
- EBC plumbing
- water in cylinder
- Old 300km speedo GB info needed....
- Intermittent white smoke
- What's supposed to screw in here?
- Gearbox rubber boots
- coilovers?
- Idle Adjuster Screw
- Too much pressure!
- Quick question: i have the Auto-meter temp+boost
- GTR injectors
- Brake pads in perth
- Power steering pump rebuild kits for the Z32TT
- replacing worn starter ring gear on flex plate
- oil fluctuation.....
- Plenum pull completed - IACV question
- Fuse Box
- brembo braided lines
- Front End Vibration
- REAR HUB OFFSET
- draining the powersteering ressy?
- TTZ HEADERS - Dyno Test Results!!
- Heater Cores, and howeth I wish to stabeth them...
- Coilovers!
- DIY clear tail lights
- Front suspension upper control arm bushes.
- ignition swich (added security)
- Vibration when idling
- Larger Turbo Inlet Piping
- 4 bolt turbo upgrades....
- Lambo Doors
- fuel pump query (more kill switch stuff)
- Noob Question (Coolant)
- NA rear brake rotor size A-spec
- Ticking Noise
- Which wheel bearing do I get???
- Need some help with Rim offsets
- 2 Things To Ask
- AT owners with oil coolers
- Tein HA?
- King Kong car alarms
- Foam in coolant
- Turbo Compressor outlets. Why are
- under bonnet support bars?
- scratching sound from rear of car
- Installed a Single Piece Tailshaft and WOW
- tech adjust the seatbelt spring
- zed brakes,?
- Heater Core Bypass, need some help.
- Match porting
- Auto shift kits
- water injection
- oil puddles?
- steering wheel shaking while braking
- 32GTR turbo's
- Brake squeal problems...ideas?
- Cruise control: Series 1 vs. Series 2?
- New Engine
- Just had a new intercooler fitted and now
- Tighter Gearbox
- replacing clutch line
- Blind luck????.....Bad luck????
- Hi Beams not so hi
- PP in progress (pics) + help identify oil leak
- Magnaflow cats, anyone using them?
- Sticky lifters - valve seat issues
- What bulbs does 92 twin tubo 300zx use?
- Low PSI... any help
- Blown ign. cont. fuse
- Dying Speedo...
- Jasma exhaust quality?
- Help...
- now read this ,, now read this
- leaking oil..
- HELP! Broken down in the ACT
- level of boost?
- anyone with a tt!
- Need help identifying strange engine noise!! Lifters?
- wheres the choke lever?
- TT PS Pump diagram?
- Dash lights not working after head unit install
- speedo cluster clear cover replacement
- Engine Noise/rattle
- inlet manifold modification....
- Cruise Control not active Import 300zx 2+2 Manual NA With
- new 300k dash gauges
- fuel economy
- Vibration in Rear
- timing belt need help :)
- HELP - wheel bearing dramas!
- LAMBO DOORS !!
- strange noise coming from dash
- What does JUN cams do?
- BEST TURBOS for a Stock TT Engine
- I think i know... but just to be sure (long)
- Braking problems - again!
- Checking engine internals
- what does a bearing kit cost for the 5 sp gear box tt ....
- Quickest Aussie N/A Zed?
- How long can you run with no O2's?
- Fuel Leak?
- Removing side mirrors?
- Engine or half cut for a conversion?
- I am looking for parts
- 93 TT engine
- Which is the best noisy lifter remedy?
- Lifters . Overfilling? Underfilling?
- Air hose? Safe to just rip her out and change?
- Squeaking noise from driver side rear. Longish
- Making slow progress with my 450ZX
- Need Do To An Oil Change, Which Oil???
- will i have problems with 20"z on my 300 will they fit???
- Carbon fiber drive shaft length
- HOW TO KEEP YOUR WASTEGATE TIGHTLY CLOSED ????
- SHIFT KIT/VALVE BODY inspection ?
- NA ecu to TT spec...can it be done?
- Brake Upgrade Kit - Engineer Cert?
- Greddy Profec BSpec 11
- ignition system (long)
- Speedo and guage issues...
- Engine Oil Capacity
- low beam lights
- Main bolt torque settings
- Coolant leak from the back of the engine
- NEED help fast!
- Mod Plate
- One of two things
- Under bonnet heat shield sealing edges?
- Mitsubishi CAS
- turbo has oil leak!
- Wastegate question...
- Port matched plenums
- Can you fit a baby seat to a 2+2....
- rear brake dust gaurds
- injector seals
- anyone got conzult?
- Erratic idle.. again
- gauges mounted in upper din
- HICAS
- EBC/boost comming on harder at lower revs ?
- Missfiring!!!
- cat warning light
- idle adjustment
vBulletin® v3.8.4, Copyright ©2000-2010, Jelsoft Enterprises Ltd.